Flush Mixed Material - Graco XM Installation-Parts

Flush Mixed Material

Flush Mixed Material
Flush Mix Manifold
Use Solvent Pump
1. Press Stop to turn off system. Engage trigger
lock. Remove spray tip.
ti1949a
2. Ensure sampling valves (AE, AF) and mix manifold
valves (AH, AJ) are closed.
AE
AH
16
3. Open solvent shutoff valve (AK) at mix manifold.
4. Open solvent pump air valve (CB). Pull out and
slowly turn solvent pump air regulator (CG) clock-
wise to increase air pressure. Use lowest possible
pressure.
.
CB
5. Disengage trigger lock and trigger gun into a
ti1948a
grounded pail. Use a pail lid with a hole to dispense
through. Seal around hole and gun with a rag to pre-
vent splash back. Be careful to keep fingers away
from front of gun. Flush out mixed material until
clean solvent dispenses.
AF
AK
AJ
ti1950a
CG
ti1953a