Installing The Flexstack Module - Cisco Catalyst 2960 Installation Manual

Chapter 1 Switch Installation

Installing the FlexStack Module

Use a flat-blade screwdriver to remove the FlexStack module blank cover on the switch back panel.
Step 1
Figure 1-1
Step 2 Grasp the FlexStack module on the sides, and insert it into the module slot. Push the module in
completely until you feel it snap into place.
Figure 1-2
Secure the screws tightly on each side of the module.
Step 3
Figure 1-3
Note
OL-19732-04
Removing the Blank Cover
Inserting the FlexStack Module
Securing the FlexStack Module
Make sure the screws are only finger-tight to avoid overtightening.
RA TIN G
10 0-2 40 ~
12 -6A , 50
-60 Hz
RA TIN G
10 0-2 40 ~
12 -6A , 50
-60 Hz
Catalyst 2960-S Switch Hardware Installation Guide
Planning a Switch Stack
1-7