Installing A Fabric Module - Cisco Nexus 9508 Hardware Installation Manual

Installing a Fabric Module

1 Pull on both handles to remove the fabric module
from the chassis.
2 Rotate both ejector handles to the front of the
module.
d) Rotate both handles back to the front of the module until they click in place. Fasten each handle to the module using
the captive screw on the back of the handle. Tighten the screw to 8 in-lb (0.9 N·m) of torque. See Callouts 2 and 3
in the previous figure.
e) Place one hand under the fabric module to support its weight. Place your other hand on the front of the module, and
slide the module out of the slot.
f) Rotate the module 90 degrees and lay it flat on an antistatic surface or in an antistatic bag.
Installing a Fabric Module
Before you begin
• Wear an electrostatic discharge (ESD) wrist strap or other ESD protective device while handling modules.
• Prepare an antistatic surface or packing materials for each module that you remove from the chassis.
• Be sure that you are replacing a fabric module with the same type of fabric module. All the fabric modules
Cisco Nexus 9508 ACI-Mode Switch Hardware Installation Guide
66
that are installed in the switch must be the same type.
Replacing or Installing Modules, Fan Trays, and Power Supplies
3 Screw in the 2 captive screws (1 on each handle) to
the module. Tighten each of these screws to 8 in-lb
(0.9 N·m) of torque.