Cisco PA-2CT1 Installation And Configuration Manual page 35

Figure 17
Step 6
This completes the procedure for removing a port adapter from a Cisco 7200 series router.
Replacing a Port Adapter
Use the following procedure to install a new port adapter in a Cisco 7200 series router:
Step 1
Step 2
Step 3
Figure 18
Slot
guide
Step 4
Caution
cables. Trying to do so will disrupt normal operation of the router.
Handling a Port Adapter
Metal carrier
Printed circuit board
Place the port adapter on an antistatic surface with its components facing upward, or in a
static shielding bag. If the port adapter will be returned to the factory, immediately place
it in a static shielding bag.
Attach an ESD-preventative wrist strap between you and an unfinished chassis surface.
Use both hands to grasp the port adapter by its metal carrier edges and position the port
adapter so that its components are downward. (See Figure 17).
Align the left and right edge of the port adapter metal carrier between the guides in the
port adapter slot. (See Figure 18.)
Aligning the Port Adapter Metal Carrier Between the Slot Guides (Cisco 7206
Shown)
With the metal carrier aligned in the slot guides, gently slide the port adapter halfway into
the slot.
Do not slide the port adapter all the way into the slot until you have connected all required
Installing or Replacing a Port Adapter in Cisco 7200 Series Routers
ETHERNET 10BT
Channelized T1 Port Adapter Installation and Configuration
TOKEN RING
FAST ETHERNET INPUT/OUTPUT CONTROLLER
Note: This adapter alignment
applies to any port or service
adapter.
35