Cisco PA-2CT1 Installation And Configuration Manual page 29

The following example of the show interfaces serial slot/port adapter/port/pri-group command
shows all of the information specific to the same interface port (interface port 1 in chassis slot 3, port
adapter slot 1) when the port is configured for ISDN PRI:
Router# show interface serial 3/1/1:23
Serial3/1/1:23 is up, line protocol is up(spoofing)
Hardware is cxBus T1
Internet address is 10.1.15.1
MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive set (10 sec)
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions alarm present
Timeslot(s) Used:1-24, Transmitter delay is 0 flags, transmit queue length 0
In the preceding example, the term "spoofing" indicates that the interface is configured for
Note
ISDN PRI. The term "spoofing" is indicated only on timeslot 24 (the D channel), which is
recognized by the system as timeslot 23.
The show version (or show hardware) command displays the configuration of the system hardware
(the number of each interface processor type installed), the software version, the names and sources
of configuration files, and the boot images. Following is an example of the show version command
used with a Cisco 7500 series router:
Router# show version
Cisco Internetwork Operating System Software
IOS (tm) GS Software (RSP-A), Version 11.1(10)CA
Copyright (c) 1986-1996 by cisco Systems, Inc.
Compiled Sat 10-Aug-96 17:56 by biff
Image text-base: 0x600108A0, data-base: 0x60952000
ROM: System Bootstrap, Version 11.1(5), RELEASE SOFTWARE
ROM: GS Software (RSP-BOOT-M), Version 11.1(10)CA, RELEASE SOFTWARE
Router uptime is 5 days, 4 minutes
System restarted by reload
System image file is "rsp-jv-mz", booted via slot0
cisco RSP2 (R4600) processor with 16384K bytes of memory.
R4600 processor, Implementation 32, Revision 2.0
Last reset from power-on
G.703/E1 software, Version 1.0.
Channelized E1, Version 1.0.
SuperLAT software copyright 1990 by Meridian Technology Corp).
Bridging software.
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
TN3270 Emulation software (copyright 1994 by TGV Inc).
Primary Rate ISDN software, Version 1.0.
Chassis Interface.
1 EIP controller (6 Ethernet).
Channelized T1 Port Adapter Installation and Configuration
Configuring 2CT1 Interfaces
29