Grounding The Generator; Operating The Generator; Starting The Engine; Connecting Electrical Loads - Briggs & Stratton GENERAC 1653-0 Owner's Manual

GROUNDING THE
GENERATOR
The National Electric Code requires the frame and
external electrically conductive parts of the generator be
properly connected to approved earth ground. Local
electrical codes may also require proper grounding of the
unit. For this purpose, a grounding wing nut (Figure 1) is
provided on the cradle.
Figure 1 — Grounding Wing Nut
Grounding
Wing Nut
Generally, connecting a No. 12 AWG (American Wire
Gauge) stranded copper wire to the grounding wing nut
and to an earth–driven copper or brass grounding rod
(electrode) provides adequate protection against electrical
shock. However, local codes may vary widely. Consult with
a local electrician for grounding requirements in your area.
Be sure to keep the ground wire attached while you
connect the electrode.
Properly grounding the generator helps prevent electrical
shock if a ground fault condition exists in the generator or
in connected electrical devices, especially when the unit is
equipped with a wheel kit. Proper grounding also helps
dissipate static electricity, which often builds up in
ungrounded devices.
OPERATING THE
GENERATOR
CAUTION!
NEVER start or stop unit with
electrical loads connected AND with the connected
devices turned ON.

Starting the Engine

Disconnect all electrical loads from the generator. Use the
following start instruction steps by numerical order:
Generac Portable Products 3250 Watt Generator
6
1. Turn the fuel valve to the "On" position (Figure 3).
Figure 3 — Fuel Valve
Fuel Valve is shown
in the On position
2. Place the choke lever in the "Choke" position
(Figure 4).
Figure 4 — Choke Positions
3. Set the rocker switch to "On" position (Figure 5).
Figure 5 — Rocker Switch
Rocker Switch is
shown in On position
4. Grasp the recoil handle and pull slowly until slight
resistance is felt. Then pull rapidly to start engine.
5. Move choke lever to "Run" position a short distance
at a time over several seconds in warm weather or
minutes in cold weather. Let engine run smoothly
before each change. Operate with choke in "Run"
position.
Refer to the engine owner's manual for complete
starting instructions.

Connecting Electrical Loads

• Let engine stabilize and warm up for a few minutes after
starting.
• Plug in and turn on the desired 120 Volt AC, single
phase, 60 Hz electrical loads.