Product Overview; Specifications; Attachments/Accessories; Operation - Toro 03485 Operator's Manual

Product Overview

Specifications

Model Number
03485
03486
03487
03488

Attachments/Accessories

A selection of Toro-approved attachments and accessories is available for use with the machine to enhance
and expand its capabilities. Contact your Authorized Service Dealer or Distributor or go to www.Toro.com for
a list of all approved attachments and accessories
To best protect your investment and maintain optimal performance of your Toro equipment, count on Toro
genuine parts. When it comes to reliability, Toro delivers replacement parts designed to the exact engineering
specification of our equipment. For peace of mind, insist on Toro genuine parts.

Operation

Note:
Determine the left and right sides of the
machine from the normal operating position.

Making Adjustments

Adjusting the Bedknife to the Reel
Use this procedure to set the bedknife to the reel and
to check the condition of the reel and bedknife and
their interaction. After completing this procedure,
always test the cutting unit performance under your
field conditions. You may need to make further
adjustments to obtain optimal cutting performance.
Important:
Do not overtighten the bedknife to the
reel or you will damage it.
•
After backlapping the cutting unit or grinding the
reel, you may need to mow with the cutting unit for
a few minutes and then perform this procedure
to adjust the bedknife to the reel as the reel and
bedknife adjust to each other.
•
You may need additional adjustments if the turf is
extremely dense or your cutting height is very low.
You will need the following tools to complete this
procedure:
•
Shim (0.002 inch)—Toro Part No. 125-5611
•
Cutting performance paper—Toro Part No.
125-5610
1. Position the cutting unit on a flat, level work
surface.
Net Weight
37 kg (82 lb)
39 kg (85 lb)
42 kg (92 lb)
44 kg (97 lb)
8
2. Turn the bedbar adjusting screws
counterclockwise to ensure that the bedbar does
not contact the reel
Figure 8
1. Bedbar adjusting screw
3. Tip the cutting unit to expose the bedknife and
reel.
Important:
Make sure that the nuts on the
back end of the bedbar adjusting screws are
not resting on the work surface
(Figure 8).
(Figure
g019940
9).