Deactivating The Timer; Activating The Timer; Sleep Timer Setting - Philips FWC170/25 User Manual

Clock/Timer
1
Press and hold CLOCK•TIMER for more than
two seconds to select timer mode.
➜ "12:00
" or "00:00" or the last timer
AM
setting starts flashing.
➜
starts flashing.
2
Press CD 1/2/3, TUNER or PROGRAM to
select the desired source.
➜ "CD1 [or 2, 3] XX:XX" indicates the CD
mode is selected.
➜ "TU XX:XX" indicates the Tuner mode is
selected.
➜ "PROG XX:XX" indicates the CD programme
mode is selected.
G Before setting timer, make sure the music source
has been prepared.
CD 1/2/3 – Load the disc(s). To star t from a
specific track, make a programme (refer to "CD
Operation - Programming the disc tracks").
TUNER – tune to the desired radio station.
3
Press à or á on the system repeatedly to set
the hour for the timer to start.
4
Press í or ë on the system repeatedly to set
the minute for the timer to start.
5
Press CLOCK•TIMER to store the timer.
➜ "TIMER ON" is displayed, followed by the set
timer "XX:XX" and the selected source.
➜
remains on the display.
G At the preset time, the selected source will play.
To exit without storing the setting
G Press Çon the system.
Notes:
– When the preset time is reached and the
selected disc tray is empty, the next available disc
will be selected. If all the disc trays are not
available, Tuner will be selected automatically.
– During timer setting, if no button is pressed
within 90 seconds, the system will exit timer
setting mode automatically.

Deactivating the timer

1
Press and hold CLOCK•TIMER for more than
two seconds.
2
Press Ç on the system to cancel the timer.
➜ "CANCEL" is displayed and the
24
Activating the timer (for the same preset
time and source)
1
Press and hold CLOCK•TIMER for more than
two seconds.
2
Press CLOCK•TIMER again to store.
➜ The last set timer information is displayed for
a few seconds and

Sleep timer setting

The sleep timer enables the system to switch to
standby mode automatically at a preset time.
1
Press SLEEP on the remote control repeatedly
to select a preset time.
➜ The selections are as follows (time in
minutes):
15 ™ 30 ™ 45 ™ 60 ™ 90 ™ 120 ™
OFF ™ 15 ...
➜ "SLEEP XX" or "OFF" is displayed. "XX" is
the time in minutes.
2
When you reach the desired length of time, stop
pressing the SLEEP button.
➜
➜ The sleep timer is now set. Before the system
switches to standby mode, a countdown of 10
seconds is displayed.
"SLEEP 10" ™ "SLEEP 9".... ™ "SLEEP 1"
™ "SLEEP"
To check the remaining length of time
after sleep timer is activated
G Press SLEEP once.
To change the preset sleep timer
G Press SLEEP again while the remaining sleep
timer is shown.
➜ The display will show the next sleep timer
options.
To deactivate the sleep timer
G Press SLEEP repeatedly until "OFF" is displayed,
or press the STANDBY ON button.
disappears.
is shown.
is shown, except for "OFF" mode.