Initial Settings Description - ADS Beyond 300 User Manual

User's Manual of Beyond 300/301 Delivery System
Hydraulic system initial settings :
1. Press "P" button about 12 second until the buzzer sound 2 short beeps (the
indicator flashes twice and then illuminates),enter initial setup state; press
P1,the buzzer sound 1short beep( P light off),escape setup state.
This step eliminates the former stroke parameters.
2. Press "P" button about 12 seconds until the buzzer sound 2 short beeps,
(the indicator flashes twice and then illuminates),enter initial setup state,
move the chair by pressing the four direction buttons to make chair down
and backrest up. Then press "O"button , and move the chair again to make
chair up to the highest and backrest down to the lowest. A t this time, press
"LP" and then finish the setting.

5.5.4 Initial settings description

Process
• Move the chair and backrest to the working position, and adjust dental
light to the desired condition ( On or Off), press the "P" button 3s till
the indicator lights on (beep 1 time, then loose button so as not to
enter the original setting state), and enters the setup procedure.
• Press the "P1" button one time， and then press the "P "button
again(beep1-2times)， setup finished and escape the setup procedure.
• P2, P3 position setup are same as the P1.
P
or or
15
P
P/N:8023488