Radio Reception; Tuning To Radio Stations; Programming Radio Stations; Automatic Programming - Philips MCM726/12 User Manual

Radio Reception

Tuning to radio stations

1
Select TUNER source.
➜
"TUNER" is displayed briefly.
2
Press BAND/DISPLAY (or TUNER on the
remote control) to select the desired waveband :
FM, MW or LW.
3
Press down on TUNING S/T (
on the remote control) and release the button.
➜
The display will show "SEARCH" until a radio
station with sufficient signal strength is found.
➜
If a FM station is received in stereo,
shown.
4
Repeat step 3 if necessary until you find the
desired station.
●
To tune to a weak station, press TUNING
S/T (
S/T
briefly and repeatedly until you have found
optimal reception.
16
S/T
is
on the remote control)

Programming radio stations

You can store up to 40 radio stations in the
memory.

Automatic programming

Automatic programming will star t with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden.
1
Press ALBUM/PRESET 4/3 to select the
preset number where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2
Press PROGRAM for more than two seconds
to activate programming.
➜
All available stations are programmed.

Manual programming

1
Tune to your desired station (refer to "Tuning to
radio stations").
2
Press PROGRAM to activate programming.
➜
PROG flashes in the display.
3
Press ALBUM/PRESET 4/3 to allocate a
number from 1 to 40 to this station.
4
Press PROGRAM again to confirm the setting.
➜
PROG disappears, the preset number and
the frequency of the preset station are shown.
5
Repeat the above four steps to store other
stations.
●
You can override a preset station by storing
another frequency in its place.