Table of Contents
Advertisement
ECO POWER
STANDBY-ON
M C M 7 2 0 M I C R O S Y S T E M
iR
USB DIRECT
ALBUM / PRESET
TUNING
TIMER SET
SOURCE
PROGRAM
DSC
Tuning to radio stations
1
Select TUNER source.
➜
"TUNER" is displayed briefly.
2
Press BAND/DISPLAY to select the desired
waveband : FM, MW or LW.
3
Press down on TUNING S/T ( à/á
on the remote control) and release the button.
➜
The display will show "SEARCH" until a radio
station with sufficient signal strength is found.
➜
If a FM station is received in stereo,
shown.
4
Repeat step 3 if necessary until you find the
desired station.
●
To tune to a weak station, press TUNING
S/T ( ¡/™ on the remote control) briefly
and repeatedly until you have found optimal
reception.
pg 001-022_MCM720_05_Eng
BAND
CLOCK SET
RECORD
DISPLAY
RDS
VOLUME
1
DBB
INCREDIBLE
SURROUND
2
1
2
is
3
4
5
●
13
Radio Reception
Programming radio stations
You can store up to a total of 40 radio stations
in the memory for each band.
Automatic programming
Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden.
Press ALBUM/PRESET 4/3 to select the
preset number where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
Press PROGRAM for more than two seconds
to activate programming.
➜
All available stations are programmed.
Manual programming
Tune to your desired station (refer to "Tuning to
radio stations").
Press PROGRAM to activate programming.
➜
PROG flashes in the display.
Press ALBUM/PRESET 4/3 to allocate a
number from 1 to 40 to this station.
Press PROGRAM again to confirm the setting.
➜
PROG disappears, the preset number and
the frequency of the preset station are shown.
Repeat the above four steps to store other
stations.
You can override a preset station by storing
another frequency in its place.
2006.4.17, 17:05
13
Advertisement
Table of Contents
