Rods To The Motor - Graco HIP e710 Series Instructions-Parts List Manual

Repair
Reassemble the the Coupling
Reassemble Reassemble the
NOTE: NOTE: Use this procedure only if the coupling NOTE:
adapter (9) and tie rods (6) have been disassembled
from the motor (3), to ensure proper alignment of the
motor shaft to the piston rod (R).
1. See Fig. 10. Screw the tie rods (6) into the motor
(3) and torque to 50-60 ft-lb (68-81 N•m).
Figure 10 Pump Assembly
16
Coupling Adapter Adapter and
Coupling Adapter
and Tie Tie Rods Rods to to to the
and Tie Rods
2. Screw the coupling adapter (9) into the motor
shaft and torque to 90–100 ft-lb (122–135 N•m).
3. Reassemble the pump to the motor. Use
the applicable instructions for your pump;
Dura-Flo, page
the Motor Motor
the Motor
15.
3A6358A