Radio Reception; Tuning To Radio Stations; Programming Radio Stations; Automatic Programming - Philips BTM630/12 User Manual

Tuning to radio stations

1
Press SOURCE repeatedly (or TUNER on the
remote control) to select the tuner source (FM
or MW).
2
Hold / on the system (or
S T
the remote control) and then release the button.
➜
The system will start searching for a radio
station with sufficient signal strength.
3
Repeat step 2 if necessary until you find the
desired station.
●
To tune to a weak station, press
5 /6
the system (or
briefly and repeatedly until you have found
optimal reception.
5 /6
on
/ on
S T
on the remote control)

Radio Reception

Programming radio stations

You can store up to a total of 40 radio stations
(30 for FM and 10 for AM) in the memory.

Automatic programming

Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden.
1
Press ALBUM • PRESET +/- on the system
(or ¡ / ™ on the remote control) to select the
preset number where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2
Press PROG on the system (or PROG/
CLOCK on the remote control) for more than
two seconds to activate programming.
➜
All available stations are programmed.

Manual programming

1
Tune to your desired station (refer to "Tuning to
radio stations").
2
Press PROG on the system (or PROG/
CLOCK on the remote control) to activate
programming.
➜
PROG flashes in the display.
3
Press ALBUM • PRESET +/- on the system
(or 3 / 4 on the remote control) to allocate a
number from 1 to 40 to this station.
4
Press PROG on the system (or PROG/
CLOCK on the remote control) again to
confirm the setting.
➜
PROG disappears, the preset number and
the frequency of the preset station are shown.
5
Repeat the above four steps to store other
stations.
●
You can override a preset station by storing
another frequency in its place.
19