Sharp KS-1800 Service Manual page 10

1. Remove the handle cover in accordance with "REMOVE OF HANDLE COVER".
2. Remove the dew receiver from upper ring.
3. Pull out the handle shafts from the upper ring.
4. Now the lid assembly is free.
1. Remove the body in accordance with "REMOVE OF BODY".
2. Remove the lid assembly in accordance with "REMOVE OF LID ASSEMBLY".
3. Upside down the outer pot, straingter 4 claws of outer pot holding to the upper ring.
4. Remove the outer pot from the upper ring.
5. Now the upper ring is free.
REMOVE OF LID COVER (LID HEATER ASSEMBLY)
1. Remove the lid assembly in accordance with "REMOVE OF LID ASSEMBLY".
2. Disconnect 3 lead wires of lid heater.
3. Remove the screw holding the lid cover to lid.
4. Separate the lid from the lid cover by insert 2 pieces of fl at type screw driver the lid cover alternately into
the gap between them.
5. Remove 3 screws holding the holder plate to lid cover.
6. Detach the lid heater from the lid cover.
7. Now the lid cover is free.
Screw
Lid cover
Holder plate
REMOVE OF LID ASSEMBLY
Tool
REMOVE OF UPPER RING
Outer pot
Claw of outer pot
Flat type screwdriver
Lid
Fig. 11
Screw
10
Upper ring
Handle shaft
Outer pot
Upper ring
Fig. 12
Fig. 13