Facts And Figures Lighting; Byte Av Lampor - Polar Electro 520 CTH DB 2020 Instruction Book

Behind the air gap on the gable rear is a strip lighting which
turns on and turns off with the switch on the air gap.
Switch lighting
behind air gap
Most caravans have lighting installed in wardrobes. This
lighting turns on and turns off with a micro switch when
the door opens or close.
Lighting LPG box
Lighting is also present in the caravan's LPG box.
The lighting is controlled with the 12 V control panel. See
reference for "Control panel 12 V", page 32.
Lighting cargo space
Lighting is also present in the caravan's cargo space.
The lighting in cargo space front is controlled with a
switch in the cargo space.
The lighting in cargo space rear is controlled with a switch
on the LED list in the cargo space.

Facts and figures lighting

Facts and figures
Interior lighting Bulb
Ceiling lamp Light diodes
Ceiling spotlights Light diodes
Spotlights i light ramp Light diodes
Reading lamp Light diodes
Kitchen lights Light diodes
Gas oven SMEV 14 V / 5 W
Roof hatch Heki De SV 8,5, 12 V/ 5 W
Luxe
Outside lamps Bulb
Tent lamp Light diodes
Position lights Light diodes
Side marking lights Light diodes
Width marking lights Light diodes
Rear gable lights Light diodes
38
Electrical system
Reading light rear
gable
Switch reading light
Our no.
401723
500158

Byte av lampor

Lighting, kitchen
1. The glass is hold in place with a framework with two clips.
Insert a thin screwdriver at each clip and carefully pry out
the framework. Remove the framework and the glass.
2. Grip the bulb and pull it out of the bulb holder.
3. Fit the new bulb with the bulb holder's small holes
and press into place.
4. Refit the glass and the framework through fitting the
framework clips in the notches and press into place.
Interior lighting, LPG oven Smev
1. Unscrew the protective glass from in front of the bulb.
2. Unscrew the bulb and install a new bulb.
3. Screw in the protective glass.
Interior lighting, LPG oven Thetford
1. Unscrew the protective glass from in front of the bulb.
2. Grip the bulb and pull it out of the bulb holder.
3. Fit the new bulb with the bulb holder's small holes
and press into place.
4. Screw in the protective glass.
Lighting roof hatch Heki De Luxe
1. Insert a thin screwdriver at the edge of the glass and
carefully pry out the glass.
2. Replace the bulb and refit (press in) the glass.