Converting The Seating Area Into A Bed - Polar Electro 520 CTH DB 2020 Instruction Book

Table of Contents

Advertisement

Leather cushions
Vacuum-clean the cushions regularly, particularly
around seams and buttons.
The cushions should be cleaned regularly with leather
cleaner, e.g. Soft Cleaner. Dab with a sponge (never rub)
until dirt and stains have been absorbed by the sponge.
Treat regularly with e.g. Leather Cream to retain the
leather's softness. The cream also provides excellent
resistance against dirt and liquid. Recommended 2-4
times a year or as required.
Do not leave the cushions in direct sunlight for long
periods.

Converting the seating area into a bed

Round seating area
1. Lower the table by pushing the latch handle down
while pressing down the table top. Release the handle
when the table is completely down and it will be
locked in the downbed position.
Latch handle,
table frame
2. Pull the two seat cushions at the sides in towards the
middle of the table and turn the cushions over. If there is a
need to fill the entire width, there is an extra bed cushion
to be purchased as an accessory (see picture below).
3. Turn the backrest cushions over and place them bet-
ween the seat cushions and the outer wall. If more
space is required, remove the corner cushions and
the backrest cushion at the gable.
Cushions in bed position
Interior
Extra bed cushion
(accessory only)
Seating area
1. Lift up the front edge of the table.
2. Pull apart the leg at the joint in the middle, and fold
the lower part of the leg in towards the table top.
Table leg
Folding
joint
3. Unhook the table from the upper wall rail, and hook
the table into the lower wall rail. Fold down the table
so that the leg rests on the floor.
4. Pull the two seat cushions in towards the middle of
the table and turn the cushions over.
5. Turn the backrest cushions over and place them
between the seat cushions and the outer wall.
Storage space under beds
To reach this space, the bed bottom must be lifted up.
To be able to lift up the bed bottom, the transit safety
catch, between the bed bottom and the bed box, must be
detached (see picture).
The beds are equipped with two spring-loaded hinges to
keep the bed bottom in the open position.
When closing, press the bed bottom down by hand.
Always lock the bed bottom using the transit safety catch
before driving with the caravan.
Hinge bed
Transit safety catch
bottom
bed bottom
27

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents