Remote Engine Start; Starting To Drive - Acura MDX SPORT HYBRID 2018 Owner's Manual

DRIVING

Remote Engine Start

Start your vehicle's power system from extended distances using the two-way
remote transmitter before you enter the vehicle.
Amber indicator:
Remote is
communicating with
vehicle.
ENGINE HOLD button:
After pressing the LOCK
button, press and hold
to start the power
system.
LOCK button
Make sure the vehicle is in a safe location when using remote engine start (i.e., a
well ventilated area, away from any flammable materials).
Starting the Engine
Press the LOCK button, then press and hold the ENGINE HOLD button to
remotely start the power system.
The power system runs for up to 10 minutes. To extend the run time for another
10 minutes, repeat the procedure during the initial 10 minutes.
While the power system is running, the climate control system adjusts the cabin
temperature, the security system remains on, and lights and accessories remain off.
Stopping the Engine
Press and hold ENGINE.
The power system will also stop if it has been running for more than 10 minutes
or if any door is opened without using the remote or keyless access.
WARNING
Engine exhaust contains toxic carbon monoxide gas.
Breathing carbon monoxide can kill you or cause unconsciousness.
Never use the remote engine starter when the vehicle is parked in a garage
or other area with limited ventilation.
96 |
Green indicator:
Confirms doors are
locked or power
system is running.
Red indicator:
Remote is out of
range or cannot
communicate with
the vehicle, or power
system is stopped.

Starting to Drive

The keyless access system allows simple push-button start.
Before Starting the Engine
Keep your foot firmly on the brake pedal when
starting the power system.
The power system is harder to start in cold weather
and in thinner air found at altitudes above 8,000
feet (2,400 m). When starting the power system
in cold weather, turn off all electrical accessories
such as the lights, climate control system, and rear
defogger in order to reduce battery drain.
Changing the Power Mode
Accessory or On Mode: Press the POWER
button once without pressing the brake pedal for
Accessory mode. Press it again while pressing the
brake pedal for On mode.
Starting the vehicle: Press and hold the brake
pedal, then press the POWER button. Keep your
foot firmly on the brake pedal when starting the
vehicle. The green READY indicator comes on and
a message appears in the MID to let you know the
vehicle is ready to drive.
Turning the vehicle off: Select Park, then press and hold the POWER button. If
you press the button and Park is not selected, the vehicle goes into Accessory
mode.
DRIVING
Brake pedal
| 97