Belt; Back Pack; Suspenders - 3M Versaflo TR-300 Series User Instructions

Belt

Select an approved belt appropriate for the work conditions. Install the belt by threading the end of the belt through
the retaining slots on the back side of the motor/blower (Fig. 9). Position the motor/blower so it rests in the small of the
back or other location around the waist. Tighten belt for a snug fit. For TR-325 (nylon web) and TR-327 (Easy Clean),
multiple belts can be interconnected to provide the wearer with a comfortable fit. An optional belt extender
(15-0099-06) is available for the TR-326 leather belt. If needed two leather belts could also be interconnected.
For TR-325 & TR-326 three optional 3 bar belt slides are included. The slides can be placed on the belt on both sides
of the motor/blower to prevent the motor/blower from moving along the belt. The third slider can be used as a keeper
for extra belt length. Place the sliders on the belt so the rounded side is on the exterior of the belt.
Back Pack (optional)
The BPK-01 back pack may be used in place of the belt (Fig. 10a):
1. With either end of the motor/blower towards the top of the back pack (end with the drag handle), thread the back
pack strap through the top retaining slot on the motor/blower and the large retaining sleeve (Fig. 10b-1) on the back
pack.
2. Thread the strap through the lower retaining slot on the motor/blower and the small retaining sleeve (Fig. 10b-2)
on the back pack.
3. Thread the strap through the buckle (Fig. 10b-3) and tighten down.
4. Don the back pack and adjust the shoulder straps for a comfortable fit.
Fig. 10a
Suspenders (optional)
The TR-329 suspenders may be used in conjunction with the TR-300 system belts.
1. Remove the tang end of the belt buckle and all 3 bar sliders on the belt.
2. Slide 2 suspender hangers on to the far end of the belt.
3. Optional - Slide one 3 bar slider (rounded side on the outside of belt) onto the belt about where the PAPR is
expected to sit.
4. Thread the belt through the TR-300 PAPR retaining slots as noted above.
5. Optional - Slide a second 3 bar slider onto the belt.
6. Slide 2 suspender hangers onto the belt.
7. Optional - Slide the third 3 bar slider on to the belt
8. Replace the tang end of the belt buckle on the belt.
9. Twist hangers so plastic "D" rings are above the belt when it is laying flat. Adjust the hangers, 3 bar sliders, and
sales@bestmaterials.com
Distributed by Best Materials® LLC
Fig. 9
8
| http://www.bestmaterials.com
Fig. 10b
| 1-800-474-7570