Transportation And Storage - Ryobi RBC36X26E Original Instructions Manual

be controlled with a switch is dangerous
and must be repaired.
■ Keep a minimum distance of 30 cm when
cleaning vehicles. The high-pressure jet
may damage or burst vehicle tires and/or
tire valves.
■ Keep cooling air intake (recoil starter area)
and muffler side of the engine at least 1 m
(3 ft.) away from buildings, obstructions,
and other combustible objects.
■ Keep the engine away from flammables
and other hazardous materials.
■ Keep away from hot parts. The muffler and
other engine parts become very hot. Use
the product with caution.
■ Keep the exhaust pipe free of foreign
objects.
■ Do not touch the spark plug and the ignition
cable when starting and operating the
engine.
■ Disconnect the spark plug wire and keep
the wire away from the plug to prevent
accidental starting.
environments.
CAUTION
Water blasting any asbestos-containing
material, including asbestos oil, is illegal.
FUEL AND REFUELLING
■ Add fuel before starting the engine. Never
remove the cap of the fuel tank or add fuel
while the engine is running or when the
engine is hot.
■ Always refuel outdoors. Never refuel
indoors or in a poorly ventilated area.
■ If the fuel tank has to be drained, do this
outdoors.
■ To reduce the risk of fire and burn injury,
handle the fuel with care. It is highly
flammable.
■ Do not smoke while handling fuel.
■ Loosen the fuel cap slowly to release
pressure and to keep the fuel from escaping
around the cap.
■ Replace all fuel tank and container caps
securely.
■ Wipe spilled fuel from the product. Move 9
m (30 feet) away from refuelling site before
starting engine.
■
■
■
Avoid dangerous
■
■
■
■
■
■
■
■
If fuel is spilled, do not attempt to start the
engine. Move the product away from the
area of spillage and avoid creating any
source of ignition until fuel vapours have
dissipated.
Store fuel in a cool, dry, and well-ventilated
area, safely away from spark and/or
flame-producing equipment. Store fuel in
containers specifically designed for this
purpose.
After stopping the engine, always pull the
trigger on the trigger handle to relieve
stored pressure in the high-pressure hose.
Failure to do so could result in serious
personal injury.

TRANSPORTATION AND STORAGE

CAUTION
Mind the weight of the product when
selecting the storage location and during
transportation to prevent accidents or
injuries.
Store the engine and allow the product to
cool down. Disconnect the product from the
water supply before storing or transporting.
Never place the product in any position
other than upright.
Drain all fuel from the tank into a container
approved for petrol. Remember to properly
replace and tighten the fuel cap.
Run the engine until it stops. This will
remove all fuel that could become stale and
leave varnish and gum in the fuel system.
Remove water from all hoses and the
pump, and empty the detergent tank before
storing the product.
Clean all foreign materials from the product.
Store it in a cool, frost-free, dry, and well-
ventilated place that is inaccessible to
children. Keep away from corrosive agents
such as garden chemicals and de-icing
salts. Do not store outdoors.
For transportation in a vehicle, secure the
product against movement or falling to
prevent injury to persons or damage to the
product.
Never carry or transport the product while
the engine is running.
Abide all government and local regulations
for the safe storage and handling of petrol.
3