Table of Contents
Advertisement
■
Keep a minimum distance of 30 cm when
cleaning vehicles. The high pressure jet
may damage or burst vehicle tires and/or
tire valves.
■
Use a garden hose with a maximum length
of 15 m and compatible with a 12 mm hose
connector.
■
Before each use, ensure that the accessory
is securely attached to the trigger gun.
OVERLOAD PROTECTION
The product has an overload protection device
that is activated when overheating or when a
current spike occurs, automatically shutting
down the power within the product. To resume
operation, disconnect the product from the
power supply, wait for about 15 minutes, and
reconnect the product to the power supply.
TRANSPORTATION AND STORAGE
CAUTION! Mind the weight of the product
when selecting the storage location and during
transportation to prevent accidents or injuries.
■
Turn off the product, disconnect from the
power supply, and allow the product to
cool down. Disconnect the product from the
water supply before storing or transporting.
Never place the product in any position
other than upright.
■
Clean all foreign materials from the
product. Storing the product in an area with
temperature below 0°C will damage the
product Store the product in a cool, dry, and
well-ventilated place that is inaccessible
to children. Keep the product away from
corrosive agents such as garden chemicals
and de-icing salts. Store the product indoors
only.
■
Remove water from all hoses and the pump,
and empty the detergent tank before storing
the product.
■
For transportation in a vehicle, secure the
product against movement or falling to
prevent injury to persons or damage to the
product.
■
Store the product indoor only. Storing the
product in an area with temperature below
0°C will damage the product.
MAINTENANCE
■
Use
only
original
replacement
parts,
4
Original Instructions
manufacturer's
accessories,
and
attachments. Failure to do so can cause
possible injury, can contribute to poor
performance, and may void your warranty.
■
Servicing
requires
knowledge and should be performed only
by a qualified service technician. Have the
product serviced by an authorised service
centre only.
■
Turn off the product, disconnect the product
from the power supply, and allow the
product to cool down. Make sure that all
moving parts have come to a complete stop:
●
before cleaning the product
●
before maintaining the product
●
before replacing spare parts
■
You may make adjustments or repairs
described in this manual. For other repairs,
have the product serviced by an authorised
service centre only.
■
Regularly inspect and maintain the product
for safe operation. RYOBI recommends
inspecting the product every 6 months.
■
Check all nuts, bolts, and screws at frequent
intervals for proper tightness to ensure that
the product is in safe working condition. Any
part that is damaged should be properly
repaired or replaced by an authorised
service centre.
SAFETY DEVICES
■
On/Off switch
The on/off switch prevents unintentional
–
operation of the product.
■
Trigger handle lock
The trigger handle lock locks the trigger
–
and prevents unintentional opening of
the high-pressure jet.
■
Pressure switch
The
overflow
–
permissible working pressure from being
exceeded. If the lever on the trigger gun
is released, the pressure switch turns
off the pump and the high-pressure jet
stops. If the lever is pulled, the pump
turns on again.
■
Overload protection
A thermal sensor protects the product
–
from overloading. The product will
automatically shut the power down while
overheating.
extreme
care
and
valve
prevents
the
Advertisement
Table of Contents
