Cisco ACS-7100-RMK Installing Manual page 17

Figure 13 Removing the PC Card Slot Cover in a Cisco 7100 Series Router
PC Card slot cover
SLOT 0
ACT
ACT
LNK LNK
FE 0 / 0
0 1
FE
0 / 1
E3 TX
RX
EN RX
CEL CAR ALM
Captive screw
Use a flat-head screwdriver to loosen the captive screw that secures the protective cover,
Step 2
and lift the protective cover.
Hold the PC Card with its connector end toward the PC Card slot.
Step 3
The PC Card must be installed with the back label facing up (see Figure 14). The
Note
PC Card is keyed and cannot be seated the wrong way. The eject button will not pop out
if the card is not completely inserted.
Figure 14 Flash Disk PC Card
Front
PC Cards do not insert all the way into the PC Card slots; the end of the card
Note
protrudes from the faceplate. Do not attempt to force the card past this point.
AC OK
DC OK
OTF
SLOT 1
PWR
0
SYS
AC OK
CO NS
RDY
AUX
DC OK
OTF
2
714 0 - 2A E3
Back
Installing Field-Replaceable Units in Cisco 7100 Series VPN Routers
Installing and Using PC Cards
17