Electrolux END52800X User Instructions page 5

5 installing your new appliance
Installing your new appliance
Clearance around your appliance
If you do not have a cupboard with a rear gap, the
recommended clearance area on top increases from
50mm to 90mm (x) and from 32mm to 72mm (y).
When positioned in a corner area, spacing of at least
350mm (400mm for E:Line models) on the hinge side will
allow the doors to open enough to enable the removal of
bins and shelves.
50mm
(x)
Recommended
airspace
CABINET
DOOR
Note:
Doors are designed to sit proud of cabinetry (not flush).
Installing your appliance
The appliance should arrive with the front adjustable
rollers wound down to tilt the top of the appliance
backwards by about 10-15mm from upright.
Height adjustable
front rollers
The stability foot should also be wound fully up so it will not
interfere with the operation of the rollers (see diagram in Step
3).
caution
The rollers are designed for forward or backward
movement only. They are not castors. Moving the
appliance sideways may damage your floor and
the rollers.
1. Roll the appliance into its final position.
2. The top of the appliance should be tilted back by
approximately 10-15mm (see diagram above). This will
allow the doors to self-close providing a consistent
door seal.
3. If the appliance is not tilted back, you can adjust the
two front rollers by turning the large, plastic roller nut
(see diagram below). This will increase the height of
the rollers. One turn of the nut will tilt the appliance
back approximately 10mm. If you have difficulty
turning the roller nut you can have someone tilt the
appliance back, so that you have better access.
Alternatively, you can access the rollers from the side,
using a flat screwdriver to help you turn the nut (see
diagram below).
Stability foot
wound up
electrolux refrigeration
(y)
10-15mm
Fixed rear
rollers
Large plastic
roller nut
4. Check the alignment of the appliance to the
surrounding cupboards. The top of the appliance
should be level from side to side (see diagram below).
If you need to adjust the level, use the adjustable
rollers as discussed in Step 3.
Aligned to
cupboards
ie. even gap
5. If the appliance now rocks from one corner to the
opposite rear corner, this means that the floor is
uneven; you will need to put some packing under
one of the rear rollers.You could use thin pieces of
solid material, such as thin board, vinyl floor tiles or
laminate. Place the packing so that it will sit under
one of the rear rollers when the appliance is rolled into
position.
6. On certain floor surfaces the appliance may roll
forward during operation. Where provided a "Roller
Stop" can be placed under the front rollers.
Roller Stop
7. You may now need to fine-tune the installation by
repeating Steps 3, 4 and 5.
8. When you have the appliance in final position, wind
the stability foot down until it just makes contact with
the floor. Whenever you need to move the appliance,
be sure to wind the foot back up so that the appliance
can roll freely.
Stability foot
wound down
9. Clean your appliance thoroughly following the
instructions on page 10 and wipe off any dust that has
accumulated during shipping.
10. Plug the appliance into the power point. Don't use a
double adaptor. If you need to roll the appliance out to
get at the power point, remember to raise the stability
foot before you do so.
11. We recommend that you let your appliance run for two
to three hours before you put any food in it. This will
allow you to check that it is operating properly.
Congratulations! You have successfully installed your new
appliance.
Top of refrigerator
is level ie. horizontal
Adjust front rollers
for uneveness of floor
eg. wind this roller
down or up