Electrolux END52800X User Instructions page 12

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
12 care and maintenance/general information
Cleaning the appliance
warning
BEFORE CLEANING: Turn appliance off at the power
point, then remove power cord from socket. This will
make sure there is no chance of getting an electric
shock.
Doors and exterior – white
You should only clean the doors with luke-warm
soapy water and a soft cloth, rinsing with clean water
and then wipe the surface with clean water and a soft
clean cloth to remove soap residue.
Doors and exterior – stainless steel
Your stainless steel appliance is manufactured from
a mark resistant stainless steel. This stainless steel
has a special advanced protective coating that eases
the removal of marks such as finger prints and water
spots. To keep your stainless steel appliance looking
at its best, you should clean it regularly. You should
only clean the stainless steel doors with luke-warm
soapy water and a soft cloth, rinsing with clean water
and then wipe the surface with clean water and a soft
clean cloth to remove soap residue.
It is important to wipe in the direction of the grain
of the stainless steel to avoid undue marking of the
surface.
caution
Do not use stainless steel cleaners, abrasive pads or
other cleaners as they are likely to scratch the surface.
Damage to this product after delivery is not covered by
your warranty
Interior
You should clean the appliance interior regularly.
It will be easiest to clean when the food supply
is low. Wash the interior with a soft cloth and use
an unscented mild soap with luke-warm water.
Thoroughly dry all surfaces and removable parts.
Avoid getting water on appliance controls. If you have
taken out any removable parts, replace them and
switch the power on before re-stocking the appliance
with food. Naturally, you should keep the interior of
your appliance hygienic by promptly and thoroughly
wiping up any food spills.
Door seals
Take care to keep door seals clean. Sticky food and
drink can cause seals to stick to the cabinet and
tear when you open the door. Wash seal with a mild
detergent and warm water. Rinse thoroughly and dry.
caution
Never use hot water, solvents, commercial kitchen
cleaners, aerosol cleaners, metal polishes, caustic or
abrasive cleaners, or scourers to clean this appliance, as
they will damage it. Many commercially available cleaning
products and detergents contain solvents that will
damage your refrigerator. When cleaning, use only a soft
cloth with an unscented mild soap and luke warm water.
Safety
electrolux refrigeration
General information
It is important to use your appliance safely. This means
you need to supervise young children and infirm persons
when they use it. You need to make sure that young
children do not play with the appliance. Follow the tips
below.
always do this
Check the power point is properly grounded - if you
are not sure get an electrician to check it.
Switch off the appliance at the power point before
you clean or move it.
If the supply cord is damaged you should have it
replaced by the manufacturer, it's service agent or
similarly qualified person. This will prevent a safety
hazard.
never do this
Never let children play with the appliance.
Never store spray cans, explosive liquids or
flammable liquids in the refrigerator.
Never store fizzy drinks in the freezer compartment.
Never lick icy foods when they first come out of the
freezer. This can freeze burn your lips and mouth.
Never try to repair the appliance yourself.
Never use electric heaters or dryers to defrost the
freezer because you can receive an electric shock.
Never use electrical appliances inside the food
storage areas.
This appliance contains insulation formed with
flammable blowing gases. For safety reasons, take
care when you dispose of it.
Do not damage the appliance circuit.
warning
When you dispose of your old refrigerator or freezer,
remove any doors. Children can suffocate if they get
trapped inside.
Switching off your appliance
If the appliance needs to be switched off for an extended
period, the following steps should be taken to reduce the
symptoms of mould:
1. Remove all food.
2. Remove the power plug from the power point.
3. Clean and dry the interior thoroughly.
4. Ensure that all the doors are wedged open slightly for
air circulation.

Advertisement

Table of Contents
loading

Table of Contents