Step 3: Connecting The Fm And Am/Mw Antennas; Step 4: Connecting The Power Cord - Philips HTR5205/98 User Manual

Basic Connections
1
AM/MW
antenna
Step 3: Connecting the
FM and AM/MW
antennas
A
Connect the supplied AM/MW loop
antenna to the AM/MW socket. Place
the AM/MW loop antenna on a shelf, or
attach it to a stand or wall.
B
Connect the supplied FM antenna to the
FM 75 socket. Extend the FM antenna
Ω
and fi x its ends to the wall.
For better FM stereo reception, connect
an external FM antenna (not supplied).
Helpful Hints:
– Adjust the position of the antennas for
optimal reception.
– Position the antennas as far away as
possible from your TV, VCR or other
radiation source to prevent any unwanted
interference.
12
1_htr5205-98_EN.indd 12 1_htr5205-98_EN.indd 12
(continued)
fi x the claw
into the slot
FM
antenna
2
AM/
Step 4: Connecting the
power cord
Notes:
– For power supply rating, refer to the
rear or bottom of the main unit.
– Turning off to standby mode does not
disconnect the unit from mains.
A
When completing all the connections, set
the voltage selector to the local power
line voltage.
B
Connect the AC power cord to the
power outlet.
The standby LED on the main unit
lights up.
Helpful Hint:
– Before making or changing any
connections, make sure that all the devices
are disconnected from the power outlet.
2007-03-30 11:53:51 AM 2007-03-30 11:53:51 AM