Toro Workman GTX Series Installation Instructions Manual page 3

Installing the Steel Cargo Bed
1. Remove the 3 flange-head screws (5/16 x 3/4 inch),
prop rod U bracket, and prop rod from the bottom of
the steel cargo bed
Important: Retain the hardware.
1. Prop rod
2. Flange-head screw (5/16
x 3/4 inch)
2. Using an overhead hoist, lower the steel cargo bed
onto the machine.
3. Align the steel cargo bed with the holes at the rear
of the machine where the 2 pivot bolts (1/2 x 4-1/2
inches) and 2 locknuts (1/2 inch) were previously
removed.
4. Install the 2 flange-head screws (1/2 x 4-1/2 inches)
through the pivot bracket and secure them with the 2
locknuts (1/2 inch) as shown in
1. Flange-head screw (1/2 x
4-1/2 inches)
2. Pivot bracket
(Figure 5).
Figure 5
3. Prop rod U bracket
Figure 6.
Figure 6
3. Locknut (1/2 inch)
5. Release the cargo-bed lever and raise the cargo bed
using an overhead hoist.
6. Slide the short end of the prop rod into the detent
slot (Figure 7).
1. Detent slot
7. Install the prop rod U bracket and prop rod to the steel
cargo bed using the 3 flange-head screws (5/16 x 3/4
inch) as shown in
1. Prop rod
2. Flange-head screw (5/16
x 3/4 inch)
3
Figure 7
2. Prop rod
Figure 8.
Figure 8
3. Prop rod U bracket