Toro Workman GTX Series Installation Instructions Manual page 2

Removing the Plastic Cargo
Bed
1. Using an overhead hoist, raise the plastic cargo bed.
2. Remove the 3 flange-head screws (5/16 x 3/4 inch)
and prop rod U bracket from the prop rod
Note: Retain the hardware if you want to install the
plastic cargo bed in the future.
1. Prop rod U bracket
2. Flange-head screw (5/16
x 3/4 inch)
3. Slide the prop rod forward out of the detent slot and
remove the prop rod
1. Detent slot
(Figure
Figure 2
3. Prop rod
(Figure 3).
Figure 3
2. Prop rod
4. Using an overhead hoist, lower the cargo bed.
5. Remove the 2 pivot bolts (1/2 x 4-1/2 inches) and 2
locknuts (1/2 inch) from the pivot bracket located at
the rear of the machine
Note: Retain the hardware if you want to install the
2).
plastic cargo bed in the future.
1. Pivot bolt (1/2 x 4-1/2
inches)
2. Pivot bracket
6. Release the cargo-bed lever and raise the cargo bed
using an overhead hoist.
2
(Figure 4).
Figure 4
3. Locknut (1/2 inch)