Setting The Speakers' Channels; Step 5: Setting Language Preference - Philips MX5600D/99 Quick Use Manual

Setting the speakers' channels

You can adjust the delay times (center and
surround only) and volume level for individual
speakers. These adjustments let you optimize
the sound according to your surroundings and
setup. Speaker settings are only active on Multi-
channel audio outputs.
Digital Output
Night mode
Analog Output
Speakers
Speaker Layout
PCM Output
Set Speaker Settings
Front L & R
Center
Surr L & R
Sub Woofer
OK to exit
1
Press SURR. (or SURROUND on the front
panel) repeatedly to select 'Multi-channel.'
2
In disc mode, press SYSTEM MENU.
3
Select icon and press 4.
4
Use the joystick (1 2 3 4) on the remote to
navigate in the menu.
Move to and press 2.
Move to 'Speakers' and press 2.
5
Press 3 4 to select (Front L&R, Center,
Surr L&R, Sub Woofer) then press 2 to enter
the speaker setting menu.
➜
The test tone will be automatically
generated.
6
Use 3 4 to adjust the settings for each
speaker that suit your surround sound needs,
which may includes :
A Turning on or off the sound output.
B Delay time settings - use the longer delay
settings when the surround speakers are
closer to the listener than the front speakers.
C Adjusting the volume levels for one or both
speakers until the sound evens.
7
Press OK to confirm.
To remove the menu
Press SYSTEM MENU.
Personal setting ...
On 3 ms
3 dB 6 dB
A B C
Getting Started
Step 5: Setting language
preference
You can select your preferred language settings so
that this DVD system will automatically switch to
the language for you whenever you load a disc. If
the language selected is not available on the disc,
the disc's default setting language will be used
instead. The exception is DVD system's menu
language, it will remain once selected.
SETUP MENU
Parental Control
Password
Menu Language
Defaults
1
In disc mode, stop playback and press SYSTEM
MENU.
2
Select icon and press 4.
3
Use the joystick (1 2 3 4) on the remote to
navigate in the menu.
Move to and press 2.
Move to 'Menu Language' and press 2.
4
Select a language and press OK.
5
Use the joystick (1 2 3 4) on the remote to
navigate in the menu.
Move to and press 2.
Move to one of the following and press 2.
– 'Audio Language' (disc's soundtrack)
– 'Subtitle' (disc's subtitles)
– 'Disc Menu' (disc's menu)
6
Select a language and press OK.
7 5 6
Repeat steps ~
To remove the menu
Press SYSTEM MENU.
English
Français
Audio Language
English
Subtitle
English
Disc Menu
English
Go to language setup page
for other settings.
23