Getting Started; Step 1: Inserting Batteries Into The Remote Control; Using The Remote Control To Operate The System; Step 2: Setting The Clock - Philips MX5600D/99 Quick Use Manual

Getting Started

Step 1: Inserting batteries into
the remote control
3
1
2
1
Open the battery compartment.
2
Insert two batteries type R06 or AA, following
the indications (+-) inside the compartment.
3
Close the cover.
Using the remote control to operate
the system
1
Aim the remote control directly
at the remote sensor (iR) on the
front panel.
2
Select the source you wish to
control by pressing one of the
source select buttons on the
remote control (for example
TV/AV, TUNER.)
3
Then select the desired function
(for example ÉÅ, S, T.)
CAUTION!
– Remove batteries if they are
exhausted or if the remote is not to be
used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.
20

Step 2: Setting the clock

The clock can be set in either 12-hour or
24-hour mode ("12:00 AM" or "00:00" for
example.)
1
Press STANDBY ON to switch on the DVD
OPEN•CLOSE
DISC 1 DISC 2 DISC 3
DISC 1
system.
DISC 2
DISC 3
DISC 4
DISC 5
2
Press and hold CLOCK•TIMER until
"SELECT CLOCK OR TIMER" appears.
iR SENSOR
STANDBY-ON
3
Press T (if necessary) to change the display
to "CLOCK," then press CLOCK•TIMER again
to confirm.
DISC/
MEDIA TUNER AUX/DI
TV/AV
4
1 2 3
Press S / T to set the minutes and hours.
4 5 6
To increase the speed, hold down S or T.
7 8 9
0
SURR. SOUND ➜
The changes in minutes will roll over to the
VOL
SYSTEM MENU DISC MENU
hours.
5
SEATING ZOOM
Press PROG to change between 12-hour and
PREV NEXT
OK
24-hour clock mode.
STOP PLAY/PAUSE
DISC SKIP REPEAT REPEAT PROGRAM
6
Press CLOCK•TIMER again to store the
setting.
➜
The clock will start working.
To view the clock time in any active
mode
G
Press CLOCK•TIMER.
➜
The clock will display for a few seconds.
Notes:
– If the DVD system is disconnected from the
power supply, it will erase the clock setting.
– If you do not press any buttons within 90
seconds, the system will exit clock setting mode.
buttons on DVD system's
front panel display panel
CLOCK•TIMER
SELECT CLOCK OR TIMER
2
CLOCK•TIMER
CLOCK
3
SEARCH
01:38 PM
4
PROG
5
13:38
CLOCK•TIMER
6 13:38