Connecting The Speakers; Connecting A Tv - Philips LX8200SA/22S User Manual

Connecting the speakers

Connect the supplied speaker systems using the supplied
speaker cables by matching the colours of the jacks and
speaker cables.
1
Press up (or down) the clip on the speaker's jack and fully
insert the stripped portion of the speaker cable into the
jack, then release the clip.
a b
2
Connect the subwoofer's AUDIO INPUT jack to the
WOOFER LINE OUT jack and then connect the
speakers as follows :
Speakers
Front Right (R) (FR)
Front Left (L) (FL)
Centre (C)
Surround Right (SR)
Surround Left (SL)
Before connecting the speakers;
G Set up the speaker stands
(refer to the accompanying
"Installation Guide") or/ and
mount the speakers onto the
mini speaker stands as shown
in the illustration.
G Remove the protective cover
only after the connection and
installation of speakers are
completed.
Notes:
– Ensure that the speaker cables are correctly connected.
Improper connections may damage the system due to
short-circuit.
– For optimal sound performance, use the supplied speakers.
– Do not connect more than one speaker to any one pair of
+/- speaker jacks.
– Do not connect speakers with impedance lower than the
speakers supplied. Please refer to the SPECIFICATIONS
section of this manual.
C
10
ONNECTIONS
c
G Use the Scart cable to connect the system's SCART
- +
G Use the S-Video cable to connect the system's
black red
black white
black green
black grey
black blue
G Use the Pr/ Cr Pb / Cb Y cables to connect the system's
G Use the video cable (not supplied) to connect the system's
G Use the supplied audio cables to connect the system's

Connecting a TV

You must connect a TV to the DVD system in order to use
the DVD system.
IMPORTANT!
– There are various ways to connect the system
to a TV (as shown in the illustration below). You
only need to make ONE of the best connections,
depending on the capabilities of your TV system.
– Never connect your TV using the component
(Pr/Cr Pb/Cb Y) video jacks unless your TV can
accept progressive signals.
If your TV has a SCART input connector
OUT jack to the corresponding SCART VIDEO IN jack on
the TV.
If your TV has a S-Video input connector
S-VIDEO jack to the S-Video input jack on the TV.
If your TV can accept progressive signals
(Progressive Scan TV)
Pr /Cr Pb / Cb Y jacks to the corresponding
Pr/ Cr Pb / Cb Y In jacks on the TV. The progressive scan
video quality is only possible through this output.
If your TV is not equipped with a SCART,
S-Video or Pr /Cr Pb / Cb Y input connector
CVBS jack to the video input jack on the TV.
To listen to the TV broadcast channels
through the home cinema sound system
AUDIO-TV IN (R/ L) jacks to the corresponding
AUDIO OUT jacks on the TV.
OR
OR
OR