Dometic COOLAIR SP950I Operating Manual page 15

CoolAir SP950
7.2 Switching on the parking cooler
A
NOTICE!
Never close all of the air nozzles of the parking cooler simultaneously.
The device would ice up inside.
I
NOTE
The first time the parking cooler is used, there may be a slight smell. This
is normal and soon goes away.
➤ With the system switched off, press the
I
NOTE
If you completely switch off the parking cooler, it can only be switched
on again using the control panel. The system can only be switched on
using the remote control if it is in standby mode. If the system is not
going to be used for a lengthy period, switch it off completely so that the
battery is not wasted supplying standby power.
✓ The fan starts at low speed.
✓ The Power LED (fig. 2 8, page 3) lights up.
✓ The digital display (fig. 2 5, page 3) shows the target temperature in °C and the
operating mode (e.g.
I
NOTE
The compressor is switched on after a delay of approx. 90 seconds.
7.3 Selecting the temperature
You can select temperatures between 17 °C and 30 °C.
➤ Press + or – on the control panel or + or – on the remote control to set the
temperature in 1 °C increments.
✓ The digital display (fig. 2 5, page 3) shows the operating mode and the
selected temperature in °C.
I
NOTE
If mode I or II fails to achieve the selected temperature, switch to the
next mode up or to automatic mode.
EN
A20
for automatic mode + temperature 20 °C).
Using the parking cooler
button.
15