Maintenance - Invacare BAR750 User Manual

Maintenance

Bottom view of bed
LINEAR ACTUATORS
The bed is equipped with 24V DC Linear Actuators Designed
with built in travel limit switches. Each actuator is equipped
with quick release pivot pins (3/8" x 2") on both ends. If
disassembled retain pivot pins and hairpin clip.
CONTROL MODULE
The Control Module is designed to control all actuators in
the system. The Control Box mounts directly on one of the
actuators as shown. Retain with screw (#8 x 1 ½").
HANDSET
The Handset is used to control all actuator functions. When
not in use, Handset hooks on the top of the side rail.
BATTERY BOX
Each bed is equipped with a 24V DC battery for use when
power cord is disconnected or power is lost.
NOTE:
Before removing connectors from control module, remove
plastic retainer strip. The retainer strip must be reassembled
after connectors are plugged back in. Assure that all
connectors are fully plugged in.
CONTROL MODULE
GROUND WIRE
Green wire from power cord
connects to bed frame. Secure
with screw and star washer.
28
BAR750
WIRING DIAGRAM