Table of Contents
Advertisement
Message
DATA IN MEMORY
CANNOT TURN OFF
ECM RX
ECM TX
HANG UP PHONE
INK TANK
CHANGED?
INSERT PHOTO
CARD
INVALID KEY/
SETTING
LOAD PAPER
(PLEASE LOAD
PAPER AND PRESS
OK or START KEY)
MACHINE IN USE
CANNOT TURN OFF
158
Troubleshooting
Cause
You are unable to turn the
machine OFF with [ON/OFF]
when documents are saved in
memory.
The machine is receiving a fax
using Error Correction Mode
(ECM).
The machine is sending a fax
using Error Correction Mode
(ECM).
The handset is not placed in the
handset cradle correctly.
You returned the scan unit to its
original position.
There is no memory card in the
card slot.
An invalid key was pressed or
an invalid setting was selected.
The multi-purpose tray is
empty.
You are unable to turn the
machine OFF with [ON/OFF]
because the machine is
performing an operation.
Action
The machine is performing an
operation. Wait until the operation
has finished, then turn OFF the
machine.
ECM receptions may take longer
than normal receptions. Set <ECM
RX> to <OFF> if you need to
receive quickly, or if you know your
local lines are in good condition.
ECM transmissions may take longer
than normal transmissions. Set
<ECM TX> to <OFF> if you need to
transmit quickly, or if you know
your local lines are in good
condition.
Replace the handset correctly.
If you replaced an ink tank, press
[ ]. If you did not, press [ ].
If you want to photo print from a
memory card, insert one (in a CF
card adapter as necessary) into the
card slot.
Check the key you want to
press or the setting you want to
enter.
Load paper in the multi-purpose
tray. Make sure the stack is below
the paper limit mark.
Press [OK], or press [Black] or
[Color].
The machine is performing an
operation. Wait until the operation
has finished, then turn OFF the
machine.
Details
—
page 171
page 170
—
page 124
page 59
—
page 40
—
Chapter 14
Advertisement
Table of Contents
