Using The Film Stabilization Feature; Using Cableclear ® Digital Noise Reduction - Toshiba REGZA 42LX177 Owner's Manual

Using the Film Stabilization feature

This feature helps to eliminate video shaking that can occur
when Cinema Mode is set to Film (3:2 pull down process
enabled).
To turn on Film Stabilization:
Press Y and open the Video menu.
1
Highlight Picture Settings and press T.
2
Highlight Advanced Picture Settings and press T.
3
4
In the Film Stabilization field, select On.
Advanced Picture Settings
Dynamic Contrast
Static Gamma
Color Temperature
Vertical Edge Enhancer
Cinema Mode
ClearFrame
Film Stabilization
Reset
To save the new settings, highlight Done and press T.
5
To revert to the factory defaults, highlight Reset and
press T.
Note:
• If you select one of the factory-set picture modes (Sports,
Standard, Movie, or Document) and then change the Film
Stabilization setting, the picture mode automatically
changes to Preference.
• When the Cinema Mode is set to Video or the ClearFrame
is set to Off (- page 79), Film Stabilization will be grayed
out and set to off automatically.
80
Chapter 7: Using the TV's advanced features
Mode: Preference
Off
0
Cool
High
Film
On
On
Done
®
Using CableClear digital noise reduction
The CableClear ® digital noise reduction feature allows you to
reduce visible interference in your TV picture. This may be
useful when receiving a broadcast with a weak signal
(especially a Cable channel) or playing a noisy video tape or
disc.
To change the CableClear settings:
Press Y and open the Video menu.
1
Highlight Noise Reduction and press T.
2
Video
Mode Sports
Picture Settings
Noise Reduction
ColorMaster Pro
xvYCC Selection
Game Mode
Theater Settings
TheaterLock
3
In the CableClear field, select your desired setting.
Noise Reduction
CableClear
MPEG Noise Reduction
Reset
Note:
• If the current input is ANT, VIDEO 1, or VIDEO 2, the
menu will display the text "CableClear." The available
selections are Off, Auto, Low, Middle, and High.
• If the current input is ColorStream HD1, ColorStream
HD2, HDMI 1, HDMI 2, or HDMI 3, the menu will display
the text "DNR." The available selections are Off, Auto,
Low, Middle, and High. Auto will react proportionally
to the strength of the noise. Low, Middle, and High will
reduce the noise in varying degrees, from lowest to
highest, respectively.
To save the new settings, highlight Done and press T.
4
To revert to the factory defaults, highlight Reset and
press T.
Off
Off
Off
ANT
Auto
Low
Done