Table of Contents
Advertisement
E - MAINTENANCE
MAINTENANCE
A: DAILY
B : WEEKLY
Or every 60
working
hours
C: MOUNTHLY
Or every
200 working
hours
D: HALF-YEARLY
Or every 1000
working hours
E : YEARLY
Or every 2000
working hours
E-22
The PYROTOME SE requires little maintenance, all component parts of
which have been designed for a long service life under intensive conditions
of use.
Be this as it may, minimal maintenance operations will contribute to
maintaning the unit in perfect working order .
Specifically, the various adjustments devices should be kept perfectly clean.
Particular attention should be paid to the cutting heads, as the obtaining of
high-quality cuts is dependent on their condition.
MAINTENANCE OPERATIONS AND RECOMMENDED FREQUENCIES
Every day if necessary,following each utilization of the apparatus :
.Check if the cutting nozzle is in good condition.
.Brush the oxide projections out of the most exposed parts and in particular,
out of the driving wheels.
First, carry out the A/ operation, then clean off and grease the sliding parts in
the suitable way explained here-after.
Parts concerned : rack crossbar and pinion, torch gas tube and its rack,
steerable wheels and castors.
Advised cleaning way : free every part from dust and brush it first with gas
oil, then with a very liquid oil and finally, wipe it with a clean cloth.
Following A/ and B/ operations, check and adjust the sliding slack of the
torch inside the electrical torch raiser.
Check the electrical applicances( especially the feeding cable). Free the
plugs and sockets from dust. Ensure the gas proofness of the circuitry.
Proceed toA/,B/, C/ operations prior to :
.Freeing the inner part of the motor case from dust.
.Measuring the motor brushes. Should their lenght be inferior to 5 mm, new
ones have to be mounted.(Don't forget to blow the dust off the collector prior
to resetting the brushes).
.Make sure that all bolts and screws are fast tightened.
Similar operation to D/ and in addition :
Check if the grease of the reduction gear is clean enough (AERO SHELL 7
quality ).
Replace the parts which are worn out.
8695 4001 / I
PYROTOME SE
Advertisement
Table of Contents
