Removing The Canbus Cable; Prerequisites; Procedure - Dell 5000 Service Manual

NOTE: Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded Box
PC and follow the steps in
follow the steps in After working inside your Embedded Box
Compliance home page at www.dell.com/regulatory_compliance.
Topics:
•

Prerequisites

•

Procedure

Prerequisites
1. Follow step 1 to step 6 in "Removing the back
2. Remove the PCI/PCIe card
Procedure
1. Disconnect the CANbus cable from the connector on the CANbus card.
2. Remove the CANbus cable from the routing guides on the chassis.
3. Slide the cable out from under the heat sink pipe.
4. Remove the hexagonal screws that secure the CANbus port to the top cover.
5. Lift the CANbus cable from the Embedded Box PC.
1. #4 40UNCx6.3 hexagonal screws (2)

Removing the CANbus cable

Before working inside your Embedded Box
cover".
(if installed).
PC. After working inside your Embedded Box PC,
PC. For more safety best practices, see the Regulatory
2. CANbus port
Removing the CANbus cable
29
53