Establish Gateway Communication; Figure 3.12 Windows Internet Protocol Properties - Honeywell NOTIFIER ONYX FirstVision Installation And Operation Manual

Establish Gateway Communication

Step 6. Select the "Use the following IP address" radio button.
Step 7. Type in your IP address information on the Internet Protocol (TCP/IP) Properties window
Step 8. Confirm that is 255.255.255.0 in the Subnet Mask field to choose the internal network (the
Step 9. Complete your entry by clicking on OK.
Step 10. Restart Windows. F
Step 11. Verify the connection by doing either of the following:
Step 12. Close any remaining windows.
Step 13. You should now
3.6 Establish Gateway Communication
NOTE: F
F V ™ Installation and Operation Manual - P/N: 53034:Rev: A2 10/29/07
IRST ISION
The "Obtain an IP address automatically" can NOT be used.
(example only shown, the address is dependent on your network).

Figure 3.12 Windows Internet Protocol Properties

address is dependent on your network).
V
IRST ISION
F V and your LAN should be established.
IRST ISION
• Check the Gateway icon in the upper left corner of the display (no X over icon means
connected).
• Ping the gateway:
• Shut down F V
IRST ISION
• Select Start >Command Prompt to display a command prompt window.
• Type in "Ping <Gateway IP Address>". If the response to the Ping is returned from
the Gateway, then the connection is established.
Figure 3.13 Command Prompt
"Establish Gateway Communication"
V 1.5 (and above) must be used with gateway versions 3.x and above.
IRST ISION
Enabling F
IRST
will automatically start. Communication between
.
V to Monitor Your Building
ISION
23