Connecting A Dvd Player With Colorstream (Component Video), A Vcr, And A Satellite Receiver - Toshiba 26HL86 Owner's Manual

Connecting a DVD player with
ColorStream ® (component video),
a VCR, and a satellite receiver
Your TV has two sets of ColorStream
component video) inputs.
You will need:
coaxial cables
•
standard A/V cables
•
– For better picture performance, if your VCR has S-video,
connect an S-video cable and standard (analog) audio
cables to the VIDEO-2 inputs on the side panel (instead of
the VIDEO-1 inputs). Do not connect both types of video
cable to VIDEO-2 at the same time or the picture
performance will be unacceptable.
– If you have a mono VCR, connect L/MONO on the TV to
your VCR's audio out terminal using the white audio cable
only.
standard audio cables
•
component video cables
•
– You can connect the component video cables (plus audio
cables) from the DVD player or satellite receiver to either
set of ColorStream terminals on the TV (HD-1 or HD-2).
The ColorStream HD-1 and HD-2 terminals can be used
with Progressive (480p, 720p) and Interlaced (480i, 1080i)
scan systems. A 1080i signal will provide the best picture
performance.
– If your DVD player or satellite receiver does not have
component video or S-video, connect standard A/V
cables to VIDEO-1. If your DVD player has HDMI video,
see page 15.
To view antenna or Cable channels:
Select the antenna/cable channel input source on the TV.*
To view the DVD player:
Turn ON the DVD player. Select the ColorStream HD-1
video input source on the TV.*
To view satellite programs using the component video
connections:
Turn on the satellite receiver. Select the ColorStream HD-2
video input source on the TV.*
To view the VCR or view and record antenna
channels:
Turn ON the VCR. Tune the VCR to the channel you want to
watch. Select the Video 2 video input source on the TV.*
Chapter 2: Connecting your TV
®
HD (high definition
To record a TV program while watching a DVD:
Turn ON the VCR. Tune the VCR to the channel to record.
Select the ColorStream HD-1 video input source on the TV*
to view the DVD.
*To select the video input source, press + on the remote control
(- page 30). To program the TV remote control to operate other
devices, see "Using the remote control to operate your other devices"
on page 19.
The unauthorized recording, use, distribution, or revision of
television programs, videotapes, DVDs, and other materials is
prohibited under the Copyright Law and may subject you to
civil and criminal liability.
From antenna
Stereo VCR
IN from ANT
CH 3
CH 4
OUT to TV
TV right side panel
TV lower back panel
Y P
P
B R
S-VIDEO COMPONENT VIDEO
OUT
From satellite dish
Y P P
B R
COMPONENT VIDEO
Satellite
S-VIDEO
IN
OUT
Satellite receiver with component video
VIDEO AUDIO
L R
IN IN
OUT
L R
TV upper back panel
DVD player with
component video
AUDIO
OUT
L
VIDEO R
OUT
AUDIO
OUT
L
VIDEO R
OUT
13