HELIX DSP PRO MK2 Manual page 22

Installation
by the jumper for adjusting the input sensitivity
of the highlevel inputs (see marking in the fol-
lowing picture).
On: Activation via highlevel speaker input is
enabled (ex works).
Off: Activation via highlevel speaker input is
disabled.
22
8. Configuration of the DSP
The general DSP settings should be con-
ducted with the DSP PC-Tool software be-
fore using the signal processor for the first
time.
Ignoring this advice may result in damaging the
connected amplifiers / the loudspeakers. Infor-
mation about connecting the DSP PRO MK2 to
a computer can be found on page 24.
9. Connecting the remote output
This output (Remote out) is used to supply re-
mote signals to the external amplifier/s. Always
use this remote output signal to turn on the am-
plifier/s in order to avoid on/off switching noises.