Loading Batteries; Operating With The Remote Control - Toshiba SD-K741SU Owner's Manual

Loading batteries

1
Open the cover.
2
Insert batteries (AAA size).
Make sure to match the + and -on the batteries to
the marks inside the battery compartment.
3
Close the cover.
Notes on batteries
Improper use of batteries may cause battery leakage
and corrosion. To operate the remote control correctly,
follow the instructions below.
● Do not insert batteries into the remote control in the
wrong direction.
● Do not charge, heat, open, or short-circuit the bat-
teries.
Do not throw batteries into a fi re.
● Do not leave dead or exhausted batteries in the
remote control
● Do not use different types of batteries together, or
mix old and new batteries.
● If you do not use the remote control for a long pe-
riod of time, remove the batteries to avoid possible
damage from battery corrosion.
● If the remote control does not function correctly or if
the operating range becomes reduced, replaced all
batteries with new ones.
● If battery leakage occurs, wipe the battery liquid
from the battery compartment, then insert new bat-
teries.

Operating with the remote control

Point the remote control at the remote
sensor and press the buttons.
Within about 7 m(23 feet) Within about 7 m(23 feet)
Distance: Maximum of 7 m (23 feet) from the front
of the remote sensor.
Angle: Approximately 30° from each direction
of the front of the remote sensor.
* Do not expose the remote sensor of the DVD
video player to a strong light source such as
direct sunlight or other illumination. If you do so,
you may not be able to operate the DVD video
player via the remote control.
Notes on the remote control
● Direct the remote control at the remote sensor of
the DVD video player.
● Do not drop or give the remote control a shock.
● Do not leave the remote control near an extremely
hot or humid place.
● Do not spill water or put anything wet on the remote
control.
● Do not disassemble the remote control.
15