Table of Contents
Advertisement
Identification of Controls (continued)
Loading batteries
1
Open the cover.
2
Insert batteries (AAA size).
Make sure to match the + and - on the
batteries to the marks inside the battery
compartment.
Caution:
Never throw batteries into a fire.
Notes
• Be sure to use AAA size batteries.
• Dispose of batteries in a designated disposal area.
• Batteries should always be disposed of with the
environment in mind.
Always dispose of batteries in accordance with
applicable laws and regulations.
• If the remote control does not operate correctly, or
if the operating range becomes reduced, replace
batteries with new ones.
• When necessary to replace batteries in the remote
control, always replace both batteries with new ones.
Never mix battery types or use new and used
batteries in combination.
• Always remove batteries from remote control if they
are dead or if the remote control is not to be used
for an extended period of time. This will prevent
battery acid from leaking into the battery compartment.
Operating with the remote control
Point the remote control at the remote sensor
and press the buttons.
Distance: About 7 m (23 feet) from the front
e:
of the remote sensor.
Angle:
About 30 in each direction of the
°
front of the remote sensor.
* Do not expose the remote sensor of the DVD
video player to a strong light source such as
direct sunlight or other illumination. If you do
so, you may not be able to operate the DVD
video player via the remote control.
Notes on the remote control
• Direct the remote control at the remote sensor of the
DVD video player.
• When using the remote control, press the buttons at
intervals of about 1 second to ensure the correct
mode of operation.
• Do not drop or give the remote control a shock.
•
Do not leave the remote control near an extremely
hot or humid place.
• Do not spill water or put anything wet on the remote
control.
• Do not open the remote control.
17
Advertisement
Table of Contents
