Steps
1. Place the hard drive into the hard-drive bracket.
2. Align the screw holes on the hard-drive bracket with the screw holes on the hard drive, and then replace the four screws (M3x3) that
secure the hard-drive bracket to the hard drive.
3. Connect the interposer to the hard drive.
4. Align the screw holes on the hard-drive assembly with the screw holes on the palm-rest and antenna assembly.
5. Replace the three (M2x3) screws that secure the hard-drive assembly to the palm-rest and antenna assembly.
6. Route the hard-drive cable through the routing guides on the palm-rest and antenna assembly and connect the hard-drive cable to the
system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
After working inside your
computer.
Removing and installing components
23