ECS 946GZT-M2 Manual page 43

37
ACPI S1/S3 (Enabled)
This item enable or disable ACPI S1/S3 function.
Resume By PS2 KB/Mouse (S3) (Disabled)
These items enable or disable you to allow keyboard/mouse activity to awaken the system
from power saving mode.
Resume By USB (S3) (Disabled)
This item allows the activity of the USB devices (keyboard and mouse) to wake-up the
system from S3 sleep state.
After Power Failure (Stay off)
This item enables your computer to automatically restart or return to its last operating
status.
Soft-Off by PWR-BTTN (Instant-Off)
Under ACPI (Advanced Configuration and Power management Interface) you can create
asoftware power down. In a software power down, the system can be resumed by Wake
UpAlarms. This item lets you install a software power down that is controlled by the
powerbutton on your system. If the item is set to Instant-Off, then the power button causes
asoftware power down. If the item is set to Delay 4 Sec. Then you have to hold the
powerbutton down for four seconds to cause a software power down.
Wake on PME (Disabled)
The system can be turned off with a software command. If you enable this item, the
systemcan automatically resume if there is an incoming call on the PCI Modem or PCI LAN
card.You must use an ATA power supply in order to use this feature. Use this item to do
wake-upaction if inserting the PCI card.
Wake on Modem Ring (Disabled)
The system can be turned off with a software command. If you enable this item, the
systemcan automatically resume if there is an incoming call on the Modem. You must use
an ATApower supply in order to use this feature.
Using BIOS