Connecting Case Components - ECS 946GZT-M2 Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
10

Connecting Case Components

After you have installed the motherboard into a case, you can begin con-
necting the motherboard components. Refer to the following:
1
Connect the CPU cooling fan cable to CPU_FAN.
2
Connect the system cooling fan connector to SYS_FAN.
3
Connect the case speaker cable to SPK.
4
Connect the case switches and indicator LEDs to the PANEL.
5
Connect the standard power supply connector to ATX1.
6
Connect the auxiliary case power supply connector to ATX12V1.
Connecting 20/24-pin power cable
Users please note that the 20-pin and 24-pin power cables can both be connected
to the ATX1 connector. With the 20-pin power cable, just align the 20-pin power
cable with the pin 1 of the ATX1 connector. However, using 20-pin power cable
may cause the system to become unbootable or unstable because of insufficient
electricity. A minimum power of 300W is recommended for a fully-configured
system.
20-pin power cable
24-pin power cable
With ATX v1.x power supply, users please note
that when installing 20-pin power cable, the
latche of power cable falls on the left side of
the ATX1 connector latch, just as the picture
shows.
With ATX v2.x power supply , users please
note that when installing 24-pin power cable,
the latch of power cable clings to the right side
of the ATX1 connector latch.
Installing the Motherboard

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents