Avaya J129 Installing And Administering page 70

Appendix
Parameter name
C
CALL_TRANSFER_MODE
CALLFWDADDR
CALLFWDDELAY
CALLFWDSTAT
CERT_WARNING_DAYS
CLDISPCONTENT
November 2017 Installing and Administering Avaya J129 IP Phone in third-party call control setup
Default value Description
Value Operation
• 8: 9db above nominal
• 7: 6db above nominal
• 6: 3db above nominal
• 5: nominal (default)
• 4: 3db below nominal
• 3: 6db below nominal
• 2: 9db below nominal
• 1:12db below nominal
0 Determines the call transfer mode in 3rd party
environments. Valid value is 0 or 1.
Null Sets the address to which calls are forwarded for
the call forwarding feature.
Users can change or replace this administered
value if CALLFWDSTAT is not 0.
Sets the number of ring cycles before the call is
forwarded to the forward or coverage address. The
default delay is one ring cycle.
0 Sets the call forwarding mode of the phone by
summing following the values:
• 1: Permits unconditional call forwarding.
• 2: Permits call forward on busy.
• 4: Permits call forward/no answer.
• 0: Disables call forwarding.
Example: a value of 6 allows call forwarding on
busy and on no answer.
60 Specifies the number of days remaining for
certificate expiry. Valid values are from 0 to 99.
1 Specifies whether the name, the number, or both
will be displayed for Call Log entries.
Value Operation
• 0: Both the name and the number will be
displayed.
• 1: Only the name will be displayed (default).
• 2: Only the number will be displayed.
Comments on this document? infodev@avaya.com
Table continues...
70