Advertisement
A
SSEMBLY AND
The following parts are included with the base STAR TRAC E-ST STEPPER:
Description
Base
Display Weldment with Neck Assembly
Handrails (1 Right, 1 Left)
Screw, .312-18 x 1.00, Hex Head
Washer, .312 Split Lock
Washer, .312 Flat
Nut, .312-18, Hex Machine
NOTE: The Display Assembly is found in its own box, along with the unit's detailed operating instructions.
UNPACKING AND ASSEMBLY
NOTE: Inspect the shipping carton for any parts that may be missing BEFORE discarding the carton. Items can shift during trans-
portation, and may be accidentally discarded with the carton. If any parts are missing, please contact Star Trac Support at 800-503-
1221. Have the serial number of the STAR TRAC E-ST STEPPER, and the part num-
ber(s) of the missing parts ready so they may be shipped to you.
1. Unpack the Shipping Carton
Open the top of the STAR TRAC E-ST STEPPER box, remove the
handrails and place aside. Remove the Display weldment/Next assem-
bly and place aside. Remove the fasteners and place aside. Remove
remaining packing material, and carefully remove from the pallet base.
Note: The display comes in a seperate box.
2. Removing the Shrouds
Remove the 6 screws that hold on the center shroud in place.
Next remove the 6 screws that hold the side shrouds in place.
Remove the side shrouds from frame. Set the 3 shrouds and
12 screws aside for later use.
STAR TRAC E-ST STEPPER
S
ETUP
Qty
1
1
2
4
4
4
4
Install Guide
Description
Screw, 1/4-20 x 1.25, Hex Head
Washer, 1/4 ID Type B, Flat
Screw, 1/4-28 x 1/2, Button Head
Qty
4
4
4
Advertisement
