Information About The Hardware Plug And Play Mechanism; Information About The Bus Cable Used - Siemens SIMATIC NET CP 1411 Installation Instructions Manual

Installation Instructions CP 1411

3.4.7 Information about the Hardware Plug and Play Mechanism

Description
Caution! Double
Assignments

3.4.8 Information about the Bus Cable Used

Description
42
The CP 1411 module has a hardware Plug and Play mechanism.
With other operating systems not listed above and without soft-
ware Plug and Play capability, the hardware Plug and Play
mechanism of the module must be disabled!
When shipped, however, the Plug and Play mechanism of the CP
1411 is activated on the module.
You can deactivate the hardware Plug and Play mechanism with
the AMINSTAL program. In the program, this is known as the
"PnP Configuration".
Make sure that the hardware resources you assign to the CP 1411
are not already assigned to another card or from your BIOS.
Double assignment, particularly of the I/O address and the DMA
channel can block your computer! If this happens, you must remove
the card with the same configuration (DMA or I/O address) as the
CP 1411 or switch it inactive, reconfigure the CP 1411 and then rein-
stall the other card.
If this is not possible, you must remove the CP 1411 and install it on a
different computer (on which the required I/O address or DMA channel
is not yet being used).
Make sure that the selected interrupt is not already reserved for PCI
specifications in your BIOS.
Information about the bus cable used is not necessary since the driver
automatically recognizes the attached bus cable (automatic port selec-
tion).
Installationsanleitung CP 1411
C79000-Z8974-C24-05