Step 9 - Connecting The Power Cords - LSI CTS2600 Initial Setup Manual

Step 9 – Connecting the Power Cords
"Things to Know – AC Power
"Steps to Connect – Power
IMPORTANT Make sure that you do not turn on the power to the controller-drive
Things to Know – AC Power Cords
For each AC power connector on the controller-drive tray, make sure that you use a
separate power source in the cabinet. Connecting to independent power sources
maintains power redundancy.
You can use the power cords that are shipped with the controller-drive tray with typical
outlets used in the destination country, such as a wall receptacle or an uninterruptible
power supply (UPS). The power cords are not intended for use in a cabinet.
Steps to Connect – Power Cords
The controller-drive tray has standard power connections to an AC power source.
IMPORTANT Make sure that you do not turn on power to the controller-drive tray or
LSI CTS2600 Controller-Drive Tray Initial Setup Guide
Navigation Aid
Cords"
Cords"
tray or the connected drive trays until this initial setup guide instructs
you to do so. For the correct procedure for turning on the power, see
"Turning on the Power and Checking for
the connected drive trays until this guide instructs you to do so. For the
proper procedure for turning on the power, see
and Checking for Problems" on page 59.
Page 57
Page 57
Problems" on page 59.
"Turning on the Power
57