Detection Area Of The Reflective Sensor; Effective Print Area - Toshiba B-SX6T Series Owner's Manual

7. SUPPLY SPECIFICATIONS

7.1.3 Detection Area of the Reflective Sensor

The detection range of the Reflective Sensor of the movable sensor is 70 mm from the media edge.
The Reflective Sensor of the fixed sensor is positioned at the centre of media.
The reflection factor of the Black Mark must be 10% or lower with a waveform length of 950 nm.
The Reflective Sensor should be aligned with the centre of the Black Mark.
Sensor should be positioned at
the centre of the black mark.

7.1.4 Effective Print Area

The figure below illustrates the relation between the head effective print width and media width.
Out of print range
The figure below shows the effective print area on the media.
NOTES:
1. Be sure not to print on the shaded area in the above figure. Printing this area may cause ribbon wrinkles,
resulting in a poor print quality of the guaranteed print area.
2. The centre of media is positioned at the centre of the Print Head.
3. Print quality in the 3-mm area from the print head stop position (including 1-mm non-printable area for print
speed slow down) is not guaranteed.
Min. 2.5 mm
Min. 12 mm
2.2
mm
(Head Effective Print Range)
175.0 mm (Max. media width)
Start line
1.5 mm from the
left edge of media
(backing paper width is not included.)
Fixed Sensor
70mm
Movable Sensor
170.6mm + 0.2mm
Area to be detected.
1mm
Guaranteed print area
1mm
Media width
E7- 3
ENGLISH VERSION EO1-33056
Centre of media
Detecting the black
marks on the back.
Media feed direction
Out of print range
2.2
mm
Media height
10 –1707 mm
1.5 mm from the
right edge of media
Media feed direction
Area to be detected.
7.1 Media