Toner-Related Items; Original/Copy Paper-Related Items - Toshiba e-STUDIO206 Operator's Manual

Toner-related items

Phenomenon
The toner lamp is lit.
The toner lamp is blinking.
The toner lamp does not light
even when the toner has
almost run out.
The equipment does not
become ready for copying
after the toner cartridge is
inserted.

Original/Copy paper-related items

Phenomenon
An original jams.
Copy paper jams.
Multiple feeding occurs.
Usual cause
There is only a little toners
remaining in the toner car-
tridge.
The toner cartridge is not
installed. Or it is not installed
correctly.
A toner cartridge not recom-
mended by TOSHIBA is
being used.
The toner in the toner
cartridge has run out.
The toner-remaining check
function has been disabled
since the purchase of the
equipment.
The toner cartridge inserted
is not usable for this equip-
ment.
Usual cause
An original not acceptable for
the equipment is being used.
Copy paper not acceptable
for the equipment is being
used.
The size of the copy paper in
the drawer or on the bypass
tray is not registered prop-
erly in the equipment.
Jammed paper is located in
a place you cannot see eas-
ily.
There is no gap between the
side guides and paper in the
drawer. Or the gap is too
wide.
Paper is clinging to each
other.
Before Calling Service Technician
Countermeasure
This is not an equipment malfunction.
(There is still some toner in the toner car-
tridge. Do not replace the toner cartridge
until the toner lamp starts blinking.)
Install the toner cartridge correctly.
Use a TOSHIBA-recommended toner car-
tridge. If you use a toner cartridge other
than the one we recommend and you feel
annoyed by this lighting lamp, contact
your service representative.
P.11 "Recommended toner cartridges"
Replace the toner cartridge with a new
one.
Contact your service representative.
Check the product name of the toner car-
tridge. If you can see "T-1640", this car-
tridge is usable.
Countermeasure
Check if the original is acceptable for the
equipment.
P.45 "Precautions for Automatic Docu-
ment Feeder (optional)"
Check if the copy paper is acceptable for
the equipment.
P.32 "Paper types not acceptable"
Register the size of the placed copy paper
properly.
P.37 "Preparation 3 - Registering Size
of Paper Placed"
P.51 "Preparation - Registering paper
size placed on bypass tray"
Use the paper jam position lamp to
recheck the position where the paper jam
has occurred.
P.81 "Paper Jams"
Adjust the gap between the side guides
and the paper properly.
P.33 "Placing paper in drawers"
Fan the paper well and place it again.
95