Preparation 1 - Turning Power On; Turning Power On - Toshiba e-STUDIO203 Operator's Manual

Preparation 1 - Turning Power ON

Turning power ON

1
Open the power switch cover, and then press the power switch to
"
The equipment starts warming itself up. The warm-up time takes approx. 25 seconds.
When the warm-up has finished, the [START] lamp is lit to show that the equipment is
ready for copying.
If you place an original and press the [START] button during the warm-up, copying auto-
matically starts when the warm-up has finished (= auto job start). The [START] lamp
keeps blinking from when you press the [START] button to when the warm-up finishes.
2
Key in the access code if the equipment is managed under the
access code function.
Key in the 3-digit access code, and then press the [START] button. Then the equipment
is ready for copying.
If the access code function is enabled, press the [FUNCTION CLEAR] button after
any operation has been finished to prevent unauthorized use of the equipment.
For the details of the access code setting, ask your service technician.
Turning power OFF
Open the power switch cover, and then press the power switch to "
" (ON) side.
" (OFF) side.

Preparation 1 - Turning Power ON

29